Question: How do I light my Weber grill if ignitor is broken?

How do you light a Weber gas grill with a lighter?

Insert the match holder, with lit match, down through the cooking grates, past the Flavorizer Bars and adjacent to the left burner (pictured below). Push the left control in and turn it to START/HI to igniter the left burner. Check that the flame is lit by looking through the cooking grates. You should see a flame.

How do you light a grill with a broken ignition?

How to Light a Gas Grill Manually

  1. Open the lid of your grill and find the lighting hole on the side of the grill.
  2. Once you see that, place a match in the curled end of the holder. …
  3. Turn on the gas burner closest to the hole. …
  4. After the first burner is lit, turn on adjacent burners to cross-light them.

How do you manually light a Weber BBQ?

Natural Gas Grills

  1. Open the grill lid.
  2. Make sure all the burner control knobs are turned off. …
  3. Turn the gas supply valve on.
  4. Put the match in the match stick holder and strike the match to light it. …
  5. For current Genesis and Summit models, ignite the remaining burners the same way going from left to right.
THIS IS FUN:  Quick Answer: Does rain ruin a grill?

How do you light a propane small Weber grill?

Lighting a gas BBQ

  1. First open the lid, then the gas cylinder valve.
  2. Turn the front/first controller to ‘high’ and wait two to three seconds for the gas to accumulate in the ignition chamber.
  3. Next, press the igniter button. …
  4. Now close the lid and preheat the barbecue to the desired temperature.

Why is my igniter not working?

Make sure that the igniter is making a clicking noise when you press the igniter button. If it doesn’t click, then the wires may not be connected properly, the battery may be dead or installed incorrectly, or the igniter module may have failed.

How do I get my Weber grill out of bypass mode?

If you think your grill is in bypass mode, you can reset the regulator by following these steps:

  1. Turn off all the burners and close the tank valve.
  2. Wait 60 seconds.
  3. Open the tank valve fully and wait a few seconds for pressure in the regulator and gas hose to equalize.

What do you do when your charcoal won’t light?

If it just doesn’t seem right to light your grill without lighter fluid, all we ask is that you don’t go crazy. The most you should use is 1/4 cup of fluid per pound of charcoal. Allow the lighter fluid to soak in for 30 seconds before lighting. And NEVER douse a burning fire with lighter fluid.

How do you light a BBQ without Firelighters?

If you’re wondering how to light a BBQ without firelighters, it’s fairly straightforward. Just scrunch up some small balls of newspaper (you can also dip these in cooking oil if you want) and insert them into some of the gaps in your charcoal stack.

THIS IS FUN:  Quick Answer: How do you thaw a whole cooked crab?