How do I reset my Traeger grill?

Factory Reset Grill – On grill go to menu, settings, about grill, then press and hold the ignite button until you see the Traeger logo (about 5-10 seconds). Check Firmware version – On grill go to menu, settings, about grill and confirm the grill has reset to 01.01.

Why is my Traeger not working?

If your Traeger grill fails to start, then some of the possible causes are a tripped GFCI on the outlet, bad power outlet, blown fuse on the back of the controller, bad extension cord, and break in the power cord. Your grill won’t light. … Also, your grill won’t light if no wood pellets are being fed to the firepot.

How do you reignite a Traeger?

After the firepot is empty, put the grill on high and wait for the auger to become filled with pellets. Once you start to see pellets fall into the firepot again, turn the grill off and place the internal pieces back into the grill. At this point you will be able to restart your cook.

THIS IS FUN:  You asked: How do you pack a moving Grill?

Where is the fuse located on a Traeger?

The folks at Traeger were smart enough to include a fuse to protect the controller in the event of a power issue. The fuse is located on the rear of the controller board. In older models, the fuse is contained within a black cylindrical container vertically placed on the lower left side of the panel.

Why is my Pellet grill not heating up?

A Traeger that does not heat up is most likely due to a deteriorated hot rod. … Most Traeger hot rods will wear out after a couple of years. While a bad hot rod is the most likely culprit behind my Traeger not heating up, it is also possible that my grill’s low temperature is due to insufficient airflow to the grill.

How do I reset my Traeger after power outage?

Re: Power outage procedure

Yes, just a normal startup. If the fire is still burning, unplug the power, flip the power stitch to OFF, plug the power back in, flip the power switch to the ON position, hit START and set your temperature.

How do I get my Traeger out of sleep mode?

Turning Demo Mode on or off will reboot the controller and then wake it up again in the selected mode.

  1. To turn on Demo Mode, follow these steps on the controller: Menu > Settings > Demo Mode > On.
  2. To turn Demo Mode off, follow these steps on the controller: Menu > Settings > Demo Mode > Off.

What does LEr on Traeger mean?

A Low Error Reading of LEr, is an error message you may see on an AC platform Grills (non-WiFIRE enabled) except the 2017 AC Timberline 850/1300. Getting this message means that your grill dropped below 125 degrees for more than 10 minutes and caused the grill to shut off.

THIS IS FUN:  What is a good white wine for cooking?

Why does my Traeger keep shutting off?

A Traeger grill may shut off or lose heat if it is too cold outside. Another reason the Traeger may shut off during cooking is the grill may be connected to an outlet that has “blown,” making it impossible for you to get power.

What is P setting on Traeger?

The P-Setting, short for Pause Setting, is used on some older grills to help monitor the temperature of the grill when being used in extreme cold or hot temperatures (newer grills monitor this automatically).

What kind of fuse is in a Traeger?

The controller will have a spare fuse attached at the back. The fuse is a 5 amp / 120 Volt, any other sized fuse, or wrapping the existing fuse in tinfoil, can result in damage to the control board.

How long does a Traeger hot rod last?

How Long Does A Traeger Hot Rod Last? When it comes to grilling, Traeger says you should get about a year or two of use out of it.